| Colour System: |
3-chip DLP® |
| Display Type: |
3 x 0.95" DarkChip™ DMD™
|
| DMD Specification: |
1920 x 1080 pixels native, +/- 12° tilt angle
Fast transit pixels for smooth greyscale and improved contrast. |
| Aspect Ratio: |
16x9 |
| Fill Factor |
87% |
| Key Features: |
Standard Inputs (1-8): Front End Video Capabilities
Video & Graphics Processing
- High bandwidth digital & analog receiver with 10 bit A-D.
- Automatic detection of interlaced video and implementation of 3:2 or 2:2 extraction as appropriate, with pixel based, motion adaptive interpolation and auto cadence correction.
- Displayed image frame locked to input with as low as 1 frame total latency.
- 24p and 1080p native display.
- Image enhancement for MPEG, Mosquito noise & color transients in composite sources.
Geometry Correction
- Cornerstone, Vertical & Horizontal Keystone, Pincushion & Barrel, and Image Rotation.
- Non-linear Warp adjustment by moving points on an interpolated grid.
Edge Blending
- Semi-automated multi projector tiling
- Correction for non-active pixels at the edge of the display.
HDBaseT® Interface
- Built in support for transmission of uncompressed High Definition Video over standard CAT5e/6 LAN cable.
- Allows projector to be placed up to 100m from source with low cost cabling.
Super Image Clarity
- Geometry correction and Edge Blending implemented in single stage process, retaining maximum image resolution.
Picture in Picture
- Two sources can be displayed either one within the other (PIP), or side by side, with original aspect ratios maintained.
ColorMax™
- Accurate matching of projectors in tiled or blended applications.
- User selection and storage of primary and secondary color targets.
High Bandwidth Inputs (9-11): Bypassing Front End for Minimal Latency
- Pixel mapped to the display.
- HDMI 1.4 for Side by Side, Frame Packing & Top Bottom formats.
- Dual Flash Processing can be used to multiply the displayed frame rate for 3D sources (example 144Hz display).
- FastFrame™ Smear Reduction.
- Dual Pipe processing: two sources in parallel for left and right eyes.
- Synchronisation of active glasses or polarising switcher.
Projector Controller Software
- Intuitive user interface for network control
- Simultaneous control of user-defined groups of projectors
- At-a-glance monitoring of projector status
|
| Source Compatibility |
3GSDI is SMPTE 292M, SMPTE 259M-C and SMPTE 424M compliant.
HDMI and DVI include Deep Color™ processing up to 36 bit.
DVI inputs are HDMI compatible.
Digital Audio Extraction via SPDIF for HDMI sources.
Graphics standards up to 1920 x 1200 at 60Hz via DVI or VGA.
Component Video (SD and HD) via YPrPb, RGB or RGBS.
S-Video (PAL, NTSC & SECAM)
Composite Video (PAL, NTSC & SECAM)
High Bandwidth, Pixel Mapped Path:
Dual Pipe accepts graphics standards up to 1920 x 1200 at 120Hz.
HDMI 1.4 including 3D Standards
Dual Pipe (2 x DVI) |
| Inputs/Outputs |
| Video & Computer |
| Type |
Connector |
Qty |
DVI-D / DVI-A
HDMI 1.3
3G-SDI
HDBaseT
VGA / Analog RGB
Component Video
S-Video
Composite Video
Composite Video
High Bandwidth Ports
Dual Pipe
HDMI 1.4
Audio
SPDIF Digital Output |
DVI-I
HDMI
BNC
RJ45
15-pin D-Sub
4 x BNC
4-pin Mini DIN
RCA
BNC
DVI-D
HDMI
RCA |
1
1
1
1
1
1
1
1
1
1
2
1 |
.
| Communication & Control |
| Type |
Connector |
Qty |
3D Sync Out
3D Sync In
LAN
RS232
Wired Remote In
Wired Remote Out
Service Port |
BNC
BNC
RJ45
9-pin D Sub
3.5mm Stereo Jack
3.5mm Stereo Jack
USB Type B |
1
1
1
1
1
1
1 |
|
| 3D Formats Supported |
Frame Packing Dual Pipe Frame Sequential Side By Side (half) Top and Bottom |
| HDTV Formats Supported |
1080p (23.98Hz, 24Hz, 25Hz, 29.97Hz, 30Hz, 50Hz, 59.94Hz, 60Hz), 1080i (50Hz, 59.94Hz, 60Hz), 1080sf (23.98Hz, 24Hz), 720p (50Hz, 59.94Hz, 60Hz) |
| Computer Compatibility |
Up to 1920 x 1200 |
| Bandwidth |
170 MHz on analog RGB
165 Megapixels per second on HDMI and DVI
300 Megapixels per second on Dual Pipe DVI |
| Remote Control |
Addressable IR remote control, wireless and wired with loop-through.
On-Board keypad |
| Automation Control |
RS232
LAN |
| Colour Temperature |
User selectable from 3200 to 9000K |
| Operation |
 |
| illumination Type |
2 x 465W High Intensity Discharge |
| Typical illumination Life |
Full Power: 1500 hours (up to 3000 hours in lamp sequential mode)
Eco Mode : 2000 hours (up to 4000 hours in lamp sequential mode) |
| Lenses |
| Lens |
Part No. |
Optimised Focus Range* |
Lens Shift (Frame) |
| 0.67:1 fixed HB |
105-607 |
1.1m - 10m |
Vert: 0.176 (U) 0.176 (D) frame, Hor: 0.063 (L) 0.063 (R) frame |
| 1.12:1 fixed HB |
105-608 |
3m - 15m |
Vert: 0.685 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
| 1.12:1 (short) fixed HB |
105-609 |
1.2m - 2m |
Vert: 0.685 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
| 1.16 - 1.49:1 zoom HB |
109-236 |
3m - 15m |
Vert: 0.509 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
| 1.39 - 1.87:1 zoom HB |
105-610 |
4m - 24m |
Vert: 0.685 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
| 1.87 - 2.56:1 zoom HB |
105-611 |
4m - 24m |
Vert: 0.685 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
| 2.56 - 4.16:1 zoom HB |
105-612 |
9.1m - 45m |
Vert: 0.685 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
| 4.16 - 6.96:1 zoom HB |
105-613 |
12m - 80m |
Vert: 0.685 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
| 6.92 - 10.36:1 zoom HB |
109-235 |
12m - 80m |
Vert: 0.685 (U) 0.5 (D) frame, Hor: 0.188 (L) 0.188 (R) frame |
* Lens focal ranges above are the optimised distances but are likely to focus further, please contact your RSM for more details. Lens ratio tolerances: E-Vision Series: +/-3%. HighLite Series: +/- 5%. M-Vision Series: +/- 2%. Titan Series: +/-2%, INSIGHT Series: +/-2%,
|
| Lens Mount |
Motorised and programmable shift, zoom and focus.
Intelligent Lens Memory with 5 user-definable preset positions. |
| Mechanical Mounting |
Front/Rear Table
Front/Rear Ceiling
Adjustable Front/Rear Feet
Optional RapidRig™ frame with integrated pitch, roll and yaw adjustments. |
| Orientation |
Table Top or Inverted: Yes
Pointing Up: TBD
Pointing Down: TBD
Roll (Portrait): TBD |
| Power Requirements |
90 - 240VAC 50/60Hz single phase |
| Power Consumption |
TBD |
| Thermal Dissipation |
TBD |
| Fan Noise |
TBD |
| Operating/Storage Temperature: |
Operating: 0 to 40C (32 to 104F)
Storage: -20 to 60C (-4 to 140F) |
| Operating Humidity |
20% to 90% non-condensing |
| Weight |
TBD kg / TBD lbs |
| Dimensions |
L: 72 cm (approx) W: 51 cm (approx) H: 23 cm (approx)
L: 28.3 in (approx) W: 20 in (approx) H: 9.1 in (approx) |
| Safety & EMC Regulations |
CE, FCC Class A & B, UL, CCC, KC |
| Accessories |
| Accessory |
Part No. |
Lamp Kit, 465W, 2 Lamp
Lamp, 465W
RapidRig™ Frame
Infrared Remote (Replacement)
Swivel Truss Mount Kit - fully adjustable for up to 50kg |
114-479
114-480
111-265
115-926
114-485
116-202 |
*Dimensions included for reference only and are subject to change. Please download the full set of CAD files for this display for more accurate information.
|
| Downloads |
|
| User Guide |
|