| Colour System: |
Laser Phosphor |
| Display Type: |
1 x 0.67" DarkChip™ DMD™
|
| DMD Specification: |
1920 x 1200 pixels native resolution.
Fast transit pixels for smooth greyscale and improved contrast. |
| Aspect Ratio: |
16x10 |
| Fill Factor |
|
| Key Features: |
Video & Graphics Processing
- HDMI 1.4a for Side by Side, Frame Packing, Frame Sequential & Top Bottom 3D formats.
- Synchronisation of active 3D glasses.
- DICOM simulation mode.
- Mobile High-Definition Link (MHL™) connection allows mirrored content from smartphones, tablets and other portable consumer electronics devices.
Geometry Correction
- Vertical & Horizontal Keystone correction (2D: Vertical ±30°, Horizontal±30°).
- Four Corner adjustment.
- Selectable 16:9, 4:3, Native, Letterbox and Full Screen aspect ratios.
- Digital Zoom +10~-10.
HDBaseT® Interface
- Built in support for transmission of uncompressed High Definition Video over standard CAT5e/6 LAN cable.
- Allows the projector to be placed up to 100m from the source with low cost cabling.
- HDBaseT® includes audio, Ethernet 100BaseT and RS232/IR control.
Colour Processing
- 2 x speed, 3 Segment (GBY) Phosphor wheel.
- 2 x 120Hz speed, 4 Segment (RGBY) Colour wheel.
- 10-bit colour display.
- 55% of NTSC colour gamut.
|
| Source Compatibility |
Graphics standards up to 1920 x 1200 resolution at 60Hz.
Horizontal frequency 15, 31 ~ 102kHz.
Vertical frequency 24 ~ 30Hz, 47 ~ 120Hz. |
| Inputs/Outputs |
| Video & Computer |
| Type |
Connector |
Qty |
HDMI 1.4a
HDMI 1.4a + MHL
VGA / Analog RGB
VGA / Monitor Out
Composite Video
HDBaseT
USB Type A / (5V/1.5A)
NOTE: The USB is to power WHDI™ interfaces.
Audio:
Audio IN L+R
Audio IN L+R
Mic IN
Audio OUT (variable)
Speakers |
HDMI
HDMI
15-pin D-Sub
15-pin D-Sub
RCA
8P8C (RJ45)
USB Type A
Phono
3.5 mm jack
3.5 mm jack
3.5 mm jack
5W speaker |
2
1
1
1
1
1
1
2
1
1
1
2 |
.
| Communication & Control |
| Type |
Connector |
Qty |
LAN
RS-232C
USB (for Service)
3D Sync Out
NOTE: The HDBaseT and LAN ports are not shared. |
8P8C (RJ45)
9-pin D-sub
Mini B
VESA 3-PIN mini DIN |
1
1
1
1 |
|
| 3D Formats Supported |
Frame Packing HQFS \ Frame Sequential Side By Side (half) Top and Bottom |
| HDTV Formats Supported |
1080p (24Hz, 25Hz, 30Hz, 50Hz, 60Hz),1080i (50Hz, 60Hz), 720p (50, 60Hz) |
| Computer Compatibility |
VGA, SVGA, XGA, SXGA, SXGA+, UXGA, WUXGA@60hz, Mac |
| Bandwidth |
165 MHz on analog RGB
165 Megapixels per second on HDMI |
| Remote Control |
IR remote control, 2 x IR receivers (front sensitivity up to 7m, rear sensitivity up to 10m) |
| Automation Control |
LAN control - Crestron RoomView® Connected
LAN control - Crestron eControl
LAN control - Extron
LAN control - AMX SSDP
LAN control to RS232 by Telnet
Concurrence Control for RS232/LAN
HDBaseT communication
Projector status email alerts |
| Colour Temperature |
Warm / Normal / Cold |
| Operation |
 |
| illumination Type |
Laser Light Source |
| Typical illumination Life |
20,000 hours |
| Lenses |
| Lens |
Part No. |
Optimised Focus Range* |
Lens Shift (Frame) |
| 1.15 - 1.90 :1 zoom |
N/A |
1.5m - 5.0m |
Vert: Fixed Offset 0.575 (U) frame + small variable shift. See User manual. Hor: 0.05(L) 0.05 (R) frame |
* Lens focal ranges above are the optimised distances but are likely to focus further, please contact your RSM for more details. Lens ratio tolerances: E-Vision Series: +/-3%. HighLite Series: +/- 5%. M-Vision Series: +/- 2%. Titan Series: +/-2%, INSIGHT Series: +/-2%,
|
| Lens Mount |
Manual zoom and focus with horizontal and vertical shift.
|
| Mechanical Mounting |
Front/Rear
Front/Rear Ceiling
Two adjustable front feet, 10° (43mm)
Ceiling Mount compatible chassis with 7 off M4 mounting holes available, maximum screw length 8mm (0.31") |
| Orientation |
Table Top or Inverted: Yes
Pointing Up: Yes
Pointing Down: Yes
Roll (Portrait): Yes |
| Power Requirements |
100-240VAC 50/60Hz single phase |
| Power Consumption |
Normal Mode (100%) 440W @230V 460W @110V
Eco Mode (80%) 340W @230V 360W @110V
Dimmy Mode (40%) 190W @230V 200W @110V
Standby, LAN enabled <2W @230V or 110V
Standby, LAN disabled <0.5W @230V or 110V |
| Thermal Dissipation |
Normal Mode (typical):
1570 BTU/Hour @ 110VAC
1501 BTU/Hour @ 230VAC
|
| Fan Noise |
Normal Mode Typ: 36 dBA / Max: 38 dBA
Eco Mode Support Typ: 34 dBA / Max: 36 dBA
Eco Plus Mode Typ: 34 dBA / Max: 36 dBA
Dimmy Mode Typ: 29 dBA / Max: 31 dBA
Extreme Dimmy Mode Typ: 29 dBA / Max: 31 dBA |
| Operating/Storage Temperature: |
Operating: 0° to 40°C (32F to 104F)
Storage: -20° to 60°C (-4F to 140F)
Altitude: 2,500ft to 5,500ft at a maximum of 30°C (86F)
Altitude: 5,500ft to 10,000ft at a maximum of 25°C (77F) |
| Operating Humidity |
10 to 85% non-condensing |
| Weight |
10.7 kg / 23.6 lbs |
| Dimensions |
L: 45.0 cm W: 35.0 cm H: 15.1 cm
L: 17.7 in W: 13.8 in H: 5.9 in |
| Safety & EMC Regulations |
UL/cUL, CB, CCC/CECP, FCC Class B, FDA, CE
IEC 60825-1:2007 3R
IEC60825-1:2014 Class 1
IEC EN 62471-5 Risk Group 2 |
| Accessories |
| Accessory |
Part No. |
Infrared Remote (replacement)
|
117-880 |
*Dimensions included for reference only and are subject to change. Please download the full set of CAD files for this display for more accurate information.
|
| Downloads |
PDF CAD Drawings
AUTOCAD Drawings
STEP / IGS Drawings
Lens CAD Drawings
|
| User Guide |
User Guides
Laser Risk Group Document
Important Information
|